Datamax-O'Neil M-Class Mark II Cutter Option - Manual (Page 4)

2
Step 2: Installing the Cutter
 Position the Cutter for mounting on the front of
the printer.
 Tighten the Mounting Screw to secure the
mechanism to the printer.
This completes the installation process.
Proceed to Loading Media.
Mounting Screw
Cutter
Loading Media
Before proceeding, ensure that the free end of the media has a clean, straight edge.
 Route the media through the printer (see the
Operator’s Manual for more information) and then
out through the Cutter’s Opening, as shown. Close
and latch the printhead mechanism.
 Close the cover.
 Plug in and turn ‘On’ the printer.
 Press the FEED Button to align the label’s position.
Opening
Setup and Configuration
The Cutter is plug and play; no setup or configuration is necessary. When the power is applied, the Cutter
blade will cycle, indicating that the printer has automatically sensed and enabled the Cutter for operation.
 Note: The operation of the Cutter is also controlled via software commands from the host. Be sure that your
software program is properly configured for the cutter and the desired label size.