Datamax-O'Neil MP Compact4 Mark II Tower Mounting Option - Manual (Page 2)

Overview
This document describes the contents, installation, and use of the Tower Mounting Option option for the
MP Compact printers. After verifying the contents of the kit and the tools needed, follow the steps below
to install and begin using the option.
CAUTION
For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the
printer’s power cord before beginning this installation and when performing service.
Contents of the Tower Mounting Kit
This kit contains the following item:
• 1 x Tower Mounting Kit
• 4 x Screws (MF6S 5x8)
Tools Required
To install this option, you will need
• Allen Key, 3mm
Installation
1. Fasten 2 screws at each bottom plate.
2. Hitch the upper bottom plate to the
stand.
1
2
1
1