Datamax-O'Neil OC-2_3 SERIES Shoulder Strap - Manual

OC Shoulder Strap
(220238-000)
Attaching the Shoulder Strap to an OC
Printer
To attach the shoulder strap to an OC printer, do
the following:
1. Place the printer face down so the swivel
mount, located on the bottom of the printer, is
visible.
2. Place the shoulder strap bracket in the swivel
mount on the OC printer, as shown below.
3. Rotate the shoulder strap bracket until it locks
into place, as shown below.
Adjusting the Length of the Shoulder
Strap
The length of the shoulder strap can easily be
adjusted.
Grasp the slide on the shoulder strap, and then
carefully pull the strip of the shoulder strap in the
desired direction, to make the shoulder strap
longer or shorter.
Note: The shoulder strap is designed to be used
only with the OC 2/3 printers.
Swivel mount
Note: Do not pull the loose end of the shoulder
strap all the way through the slide or it will
become detached. Leave approximately two
inches of slack.
Slides