Datamax-O'Neil PrintPAD Vehicle Mount Bracket - Manual

PrintPAD Vehicle Mount Bracket
(220257-000)
Selecting a Location
General Guidelines
• Position the bracket so there is enough room to
properly open and close the printer.
• Position the bracket so the printer is protected from
environmental elements such as moisture, tools,
and boxes.
• Position the bracket in a secure area within normal
traffic patterns.
• Do not position the bracket above, near, or relative
to the driver’s position as to interfere with normal
driving operations.
• Mount the bracket away from the driver’s head to
eliminate potential injury in the event of an
accident.
• Use only 1/4” x 20° pan head head screws for
mounting.
• Datamax-O’Neil does not accept liability for
improperly mounted or poorly placed mounting
brackets and/or printers.
• The PrintPAD Vehicle Mount Bracket works with
the PrintPAD 7900 and 9000 printers
(manufactured after March 1, 2007).
Step 1: Mounting the Bracket
1. Attach the feet to the mounting holes.
2. Use the PrintPAD Vehicle Mount Bracket as a
template to mark the four mounting holes on the
mounting surface. For guidelines on mounting and/
or installation, see Selecting a Location.
3. Drill the mounting holes at the marked locations.
4. Attach the bracket to the mounting surface using
1/4” - 20 pan head screws (not included) and the
washers (included). Thread the screws through the
washers and the mounting holes with a 1/4”- 20 nut
and lock washer, using Loctite ® .
5. Tighten securely without crushing the rubber feet.
Do not overtighten.
6. Proceed to Step 2: Attaching the Printer.
Mounting
Locking lever
PrintPAD printer
holes (4)
Padlock hole
Locking lever
Unlocked Locked
Rubber feet (4 sets) Washers (included)
1/4” x 20° pan head screws (not included)
(included)
Place feet here
Front
Back
Mounting holes (4)
Mounting dimensions
* Drill holes 9/32”
diameter
* Use 1/4” - 20 ° pan head
screws (the length is
determined by the
thickness of the
mounting surface)