Datamax-O'Neil S-Class ST Cutter Option User Manual
Page 9
7
Cutter Maintenance
Cutter maintenance is recommended after every 5,000
− 10,000 cuts, an interval that varies depending
upon the type of ticket stock being used. The need for cleaning may also be indicated when the cut
operation becomes slow or labored. To clean the cutter, proceed as follows:
CAUTION
For your safety and to avoid damaging the equipment, follow these precautions:
(1) Always turn ‘Off’ and unplug the printer before servicing the cutter;
(2) Never use a metal object on the blade; and,
(3) Keep fingers and other body parts away from the blade.
1. Turn ‘OFF’ the power switch and unplug the AC power cord. Remove the access cover.
2. Unlock the printhead latch, raise the printhead assembly and remove the ticket stock.
3. If present, remove the Memory Module from the Module Bay. Remove the two Inside Cover Screws
and loosen the two Outside Cover Screws. Raise the Electronics Cover off the printer.
Outside Cover Screws
Inside Cover Screws
Electronics Cover
Module Bay