Datamax-O'Neil S-Class DTPL Programmer’s Manual - Manual (Page 10)

DTPL Programmer’s Manual 4
Font Size Command
<Fx>
This command sets the font size. The defaults is F3.
x=
1 for Font1 characters (5x7)
2 for Font2 characters (8x16)
3 for OCRB (17x31)
4 for OCRA (5x9)
6 for large OCRB (30x52)
7 for OCRA (15x29)
8 for Courier (20x40)(20x33)
9 for small OCRB (13x20)
10 for Prestige (25x41)
11 for Script (25x49)
12 for Orator (46x91)
13 for Courier (20x40)(20x42)
Graphics Command <G>byte1,byte2,byte3,byte4,byte5,b
yte6,byte7 or
<G#>byte1,byte2...byte#
Sets the printer to Graphics Mode and sends graphic data to the
printer.
Height/Width Command <HWx,y> Multiplies the normal character height by x=Width and y=Height
Printing Length Command <PL#> Changes the normal printing length to a user defined unit length.
Each unit equals .0098” or 2 dots
Permanent Printing Length
Command <pl#> Changes the normal printing length to a user defined unit length.
Each unit equals .0098” or 2 dots and saves the value in the printer’s
Flash memory.
Permanent Ticket Length
Command <tl#> This command should only be used if the ticket length is greater than
the printing length. This value is stored in the printer’s Flash
memory.
Repeat Command <RE#> Allows the printing of any number (up to 9999) tickets without re-
transmitting the data.
Rotation Command <NR> No rotation
<RR> Rotate right (+90)
<RU> Rotate upside down (+180)
<RL> Rotate left (+270 or - 90)
This command sets the rotation mode for all the following text data.
Row/Column Command <RCx,y> This command positions the character at the row (x) and column (y).