Datamax-O'Neil S2000i User Guide - Manual (Page 17)

13
6 Bluetooth™ Communications
The printer control card communicates with the Bluetooth™ base band interface at 38,4 K Baud/sec for serial interface
printers using no parity. To select the Bluetooth™ interface, Dip Switch # 6 must be ON and all other Dip Switches must
be OFF. If required by the host application to enter 0 (digit zero) for PIN number while connecting to the BT module.
Bluetooth settings can be changed via the AT command set (Refer to 2000i_Bluetooth Addendum on Dev. CD).
The table below details the Bluetooth default settings:
Settings Value
Name Datamax-O’Neil Printer
Serial Settings
38,400,8,n,2,n
Discoverability mode Generally Discoverable
Connectivity mode GAP Connectable
Security mode Security Disabled
Fixed PIN 0 (Zero)
Set Master/Slave Policy Always let the connecting device select the master/slave role on
incoming connections
Client Profile Disable Client Services
Server Profile
Serial Port Profile Server enabled
Wireless Multi-drop mode disabled, forward to host only
Configuration over Bluetooth Enabled
Power Save mode Allow Sleep mode only
ESC sequence timing
500ms before ESC command & 500ms thereafter