Datamax-O'Neil VMP SERIES User Guide - Manual (Page 14)

VMP SERIES OF PRINTERS USER'S GUIDE
11
Audio Indicators
* If these actions do not resolve the problem, your
printer may need to be serviced. For more information,
contact a service center listed on the back page.
Beep(s) Description Action
Series of 50
short beeps
Head jam. Check for paper jam.
Check the ribbon.
1 short RF power is on (when RF
power button is pressed
and RF power was off).
None.
1 long Boot code is starting or
restarting (occurs more
than once when
downloading new
firmware).
Re-download firmware
(only if you are not
currently downloading
firmware).
2 short RF power is off (when RF
power button is pressed
and was on).
None.
5 double Out of paper. Load paper.
8 CRC firmware error. Redownload firmware.
10 Error writing to
communication controller
firmware.
Disconnect power to
the printer, then
restart the printer* or,
Perform a back door
erase and re-download
firmware. For more
information, refer to
the Programmer's
manual.*
Infinite
beeps/
toggle LEDs
Comm controller failure. Disconnect power to
the printer, then
restart the printer.*