Datamax-O'Neil VMP-1000 Paper Tray - Manual

The Paper Tray Kit (220155-000) comes with the
following (Fig. 1):
• (1) Paper Tray
• (1) Foam Block
• (1) Mounting Instructions
Note: Use Foam Block when a stack of paper is
placed directly in Paper Tray only.
Hardware / Tools required for mounting:
• Drill with 3/16” bit.
• (4) #8 Pan head or Button head screws,
Screw length to be determined by user.
• #1 Phillips screwdriver or 3/32” hex key
(optional)
• Level (optional)
Choosing a location for the Paper Tray:
1. Position the Paper Tray with enough room to
properly place a stack or box of tractor feed
paper.
2. Position the Paper Tray and paper so it is
protected from environmental elements (i.e.
moisture, tools, boxes, etc.).
3. Position the Paper Tray and paper in a
visibly secure area in normal traffic patterns.
4. DO NOT position the Paper Tray above,
near or relative to the driver’s position as to
interfere with normal driving operations.
5. Mount the Paper Tray and paper away
from the driver’s head to eliminate
potential injury in the event of an
accident.
6. Hole centers:
Left to Right = 5”
Up & Down = 5”
Recommended hole diameter for #8 screw is
3/16” (.187”).
2
Installation of the Paper Tray:
1. NOTE: VMP1000 printer must be installed
first for proper alignment of the Paper
Tray. The alignment of the Paper Tray and
paper to the printer is crucial. It may be
necessary to use a leveling device to locate
the Paper Tray properly.
2. Before mounting the Paper Tray, make sure
there is adequate space between it and the
printer for the amount of paper to be used.
(Fig. 2).
3. Mark the drill location on the mounting
surface (Fig. 3). Be mindful as to what is
on the other side of the mounting
surface. Use a 3/16” drill bit.
4. Select #8 screws to secure the Paper Tray
5. Top of screw head should not interfere with
the paper stack or box of paper.
Note: The length of the screws will vary for each
installation, and is to be determined by user.
3
Fig. 1 Fig. 2 Fig. 3