Draw-Tite 36407 FRAME HITCH User Manual

Installation instructions, Chevrolet impala, Part numbers

Advertising
background image

Installation Instructions

Chevrolet Impala

Part Numbers:

D N t E

d L

f T

i

V hi l

Drawbar Kit:

Fascia

36407
06389
90137

Hitch Shown In Proper Position

Wiring Access Location: PC3, PC4

Equipment Required: Pull wire (provided)

3500 LB Max Gross Trailer Weight

300 LB Max Tongue Weight

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Drawbar must be used in the
RISE position only.

36061

Frame Rail

Wrenches: 3/4

Drill Bits: None

Fastener Kit: 36407F

Vehicle Frame
Rail

Cross Member

1234

5234

Fasteners Typical

Access Slot
In Frame Rail
Typical Both
Side

Access Hole
In Cross Member
Both Ends

1

Qty. (4)

Carriage Bolt ½-13 x 1-1/4”

4

Qty. (6)

Hex Nut ½-13

2

Qty (6)

Block ¼ x 1 x 3

5

Qty (2)

Carriage Bolt ½ 13 x 1 3/4”

5234

Fasteners Typical
Both Sides

1.

Lower exhaust by removing rubber hangers from hanger brackets. If vehicle is equipped with dual exhaust, lower exhaust both

sides.

2.

Fishwire ½-13 x 1-1/4” lg. carriage bolts and blocks thru access slot and over holes in vehicle frame rail, both sides.

3.

Fishwire ½-13 x 1-3/4” lg. carriage bolts and blocks thru access holes in vehicle cross member and down thru holes in cross

member as shown.

4.

Raise hitch into position. Install conical toothed washers and nuts as shown.

2

Qty. (6)

Block ¼ x 1 x 3

5

Qty. (2)

Carriage Bolt ½-13 x 1-3/4

3

Qty. (6)

Conical Toothed Washer ½”

6

Qty. (4)

Pull wire

5.

Tighten all ½-13 GR5 fasteners with torque wrench to 75 lb.-ft.

z

2005, 2008, 2009, 2011 Cequent Performance Products

Sheet 1 of 3

36407N

3-23-11

Rev. E

Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft.

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

Form F206 Rev A 5605

Advertising