Asus Barebone System Vintage-PE2 - Manual (Page 42)

2 - 2 6 2 - 2 6 2 - 2 6 2 - 2 6 2 - 2 6 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
2.9 Installing a floppy disk drive
The barebone system comes with one 3.25-inch drive bay for a floppy disk
drive.
To install a floppy disk drive:
1. Remove the front panel cover.
For instructions on how to remove the front panel cover, refer to section
“2.3 Removing the side plates and front panel cover” on page 2-3 for
details.
2. Carefully insert the floppy disk
drive into the floppy drive bay.
2
3. Push the optical drive into the
bay until its screw holes align
with the holes on the bay as
shown.
2
3. Secure the floppy disk drive
with two screws.
2
3 3