Draw-Tite 20275 WIRING ADAPTER - Manual

ENGLISH
TOOLS REQUIRED:
Trim Panel Remover, Wire Crimpers
CAUTION
1 Plug Option
Using the butt connectors provided, attach
the wires from the adapter to the corresponding
wires on the electric brake control, following
the brake control installation instructions,
before attaching to the vehicle junction box d.
2 Plug Option
Plug brake control adapter into mating
receptacle on backside of brake control
before attaching to the vehicle junction box.
1. Locate the vehicle's black Electric Junction
Box in the interior of the pickup, underneath
the dashboard, left of the steering column,
just above the carpet. Remove the cover and
locate the mating connection point in the Electric
Junction Box for electric trailer brakes ef.
2. Plug the Brake Control Adapter into the
mating connection in the Electric Junction
Box. Follow all brake control manufacturer’s
installation instructions.
WARNING
Complete the installation per the electric
brake control manufacturer’s instructions
and mount the unit as directed. Perform
test procedures as instructed.
WARNING
Overloading circuit can cause fires. DO NOT
exceed lower of towing manufacturer rating or:
• Max.4 axles: 8 brakes (24 amps)
Read vehicle’s owners manual and
instructionsheet for additional information.
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEz CECI EN PREmIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRImERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
20275-037 Rev. A 7/11/13
Installation Instructions
Directives de montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
e
f
Chevy
d
Trailer Brake Controller
(Output)
Fused Trailer Brake Controller
Battery Feed
Ground
Vehicle Stop Lamp Switch
To Brake Controller (Input)
Wiring Adapter Housing
(Containing Female Terminals - Wire Side)
PAGE 1 OF 3