Draw-Tite 59508 BIKE CARRIER - NV2 - HITCH MOUNT User Manual
Page 4
Product Code:
59508
Product Name:
NV2
www.rolaproducts.com
www.rola.com.au
59508N Rev F 01/12
Cequent Performance Products - Plymouth, MI. USA.
Technical Service: (888) 521-0510
Cequent , a division of TriMas Corporation Pty Ltd.
20-50 Waterview Close, Dandenong South, VIC, Australia 3175
Ph:1300 888 051
PRINTED IN CHINA
Diagram 11
Diagram 10
Diagram 9
Please read all instructions carefully before assembly, installation and/or use of this product.
LOADING INSTRUCTIONS:
1.
Load the bike onto the rack by placing front and rear bike wheel on rim slide finger (Diagram 9). When loading
multiple bikes, alternating each bike so that handle bars do not interfere with each other.
2.
Secure the bikes by pulling the rim straps over the top of the bike wheel (Diagram 10). To prevent the bike from
swaying , secure front wheel to anti-sway finger as shown (Diagram 11).
3.
A cable lock can be used thru the cable lock loop to secure bikes to rack.
4.
Check the rim and crank straps periodically and after stopping to insure that they are still tight and that someone has
not released them. NOTE: Insure all locks are locked, that all pins are secured, and that all straps are properly
attached prior to moving the vehicle. Failure to do so will void the warranty.