Dynasonics DXN Portable Ultrasonic Measurement System Firmware Update - Manual (Page 11)

dynasonics.com 800-535-3569 ©2012 Racine Federated Inc., all rights reserved
Step 1: Unlock System (Reboot)
Step 3: Copy Updated Files
Step 2: Update System (Reboot)
Step 4: Update Flowmeter
Step 5: Lock System (Reboot)
Unlock
Lock
Update
Flowmeter
Update
System
Copy
15:19:23 Begin Embedded Update
15:19:23 Boot... A A A t r t r t r t r T r R BB Ready
15:19:28 Embedded File:
CRC32B:
18C97728
MD5:
867B861C
7038 D7D4 A2C5
F74EE8D207CE
15:19:30 Erase ............ Success
15:19:41 Program ............ Success
15:20:11 Verify ............ Success
!Success Embedded Update!
Exiting Reprogramming Mode
Check Update Status Quit Update Utility Restart System
ORDEM & PR OGRE SSO
19 Press the Lock button and then remove the USB Update Drive
When the Lock button is pressed more code appears in the progress screen When the process is complete a request
to reboot appears in the middle of the screen
dynasonics.com 800-535-3569 ©2012 Racine Federated Inc., all rights reserved
Step 1: Unlock System (Reboot)
Step 3: Copy Updated Files
Step 2: Update System (Reboot)
Step 4: Update Flowmeter
Step 5: Lock System (Reboot)
Unlock
Lock
Update
Flowmeter
Update
System
Copy
Check Update Status Quit Update Utility Restart System
ORDEM & PR OGRE SSO
C:\Documents and Settings\FlowMeterUser>ewfm
*** Enabling overlay
Protected Volume Configuration
Type RAM
State DISABLED
Boot Command ENABLE
Param1 0
Param2 0
Presistent Data “”
Volume ID C7 A2 27 25 00 7E 00 00 00 00 00
Device Name “\Device\HarddiskVolume1” [C}
Max Levels 1
Clump Size 512
Current Level N/A
Memory used for data 0 bytes
Memory used for mapping 0 bytes
×
OK
Reboot
20 Press the OK button to reboot the system
The DXN reboots ending up at the Start screen This reboot uses a more Window’s like process and requires more
time for completion When the reboot is complete the meter should return to the Start Screen
Firmware Update Manual
Page 11 May 2013