EBARA EFQT3 - Manual (Page 5)

EBARA Fluid Handling 5
SAFETY – SECTION A
These warnings apply to EFQT series basic pumps. EBARA has no control over or particular
knowledge of the power source which will be used. Refer to the manual accompanying the power
source before attempting to begin operation.
Before attempting to open or service the
pump:
1. Familiarize yourself with this manual.
2. Disconnect or lock out the power
source to ensure that the pump will
remain inoperative.
3. Allow the pump to cool if overheated.
4.
Check the temperature before
opening any covers, plates, or plugs.
5. Close the suction and discharge
valves.
6. Vent the pump slowly and cautiously.
7. Drain the pump.
This pump is designed to handle mild
industrial corrosives, mud or slurries
containing large entrained solids. Do not
attempt to pump volatile, corrosive, or
flammable materials which may damage
the pump or endanger personnel as
result of pump failure.
After the pump has been positioned,
make certain that the pump and all piping
connections are tight, properly supported
and secure before operation.
Do not operate the pump without the
guards in place over the rotating parts.
Exposed rotating parts can catch
clothing, fingers, or tools, causing severe
injury to personnel.
Do not remove plates, covers, gauges,
pipe plugs, or fittings from an overheated
pump. Vapor pressure within the pump
can cause parts being disengaged to be
ejected with great force. Allow the pump
to cool before servicing.
Do not operate the pump against a
closed discharge valve for long periods
of time. If operated against a closed
discharge valve, pump components will
deteriorate, and the liquid could come to
a boil, pressure, and cause the pump
casing to rupture or explode.
Use lifting and moving equipment in
good repair and with adequate capacity
to prevent injuries to personnel or
damage to equipment. Suction and
discharge hoses and piping must be
removed form the before lifting.
WARNING! WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!