DE DIETRICH BSC...E - BSP...E - BESC...E - Manual (Page 16)

16
BSC...E - BSP...E - BESC...E 11/05/12 - 300027781-001-01
4.5 Measured values and adjustment parameters
*with S3 sensor only (optional)
*

The regulator has a safety system that cuts off the tank at
temperatures of over 80°C.
„ Measured value TC - Collector temperature
The value TC shows the temperature in °C given by the collector
sensor in real time.
„ Measured value TS - DHW sensor temperature
The value TS shows the temperature in °C given by the tank sensor
in real time
„ Measured value kWh - Amount of heat
The value kWh shows in kWh the total amount of heat produced by
the installation since the regulator was put into service.

The quantity of heat (kWh value) can only be used for checks
carried out for personal reasons.
„
Measured value tc - Self-calibration time
The value tc shows the self-calibration phase time remaining in
seconds. During the self-calibration phase, the pump operates at full
speed (100 %); its speed is only controlled after the self-calibration
phase.
Channel Abbreviation Range Increment Factory setting
Collector temperature TC [-50.0 ... 250.0] °C - -
Calorifier temperature TS [-50.0 ... 250.0] °C - -
Amount of heat kWh [0 ... 9999] kWh - -
Pump regime PC [0 ... 100] % - -
Self-calibration time tc [0 ... 5] minutes - -
Reference temperature difference DT [10 ... 20] K 0.1 20
Set temperature of the solar calorifier SX [20 ... 80] °C 0.1 60
Maximum collector temperature CX [100 ... 125] °C 0.1 100 °C
Self-calibration phase tu [1 ... 5] minutes 1 1
Pump minimum speed PN [50 ... 100] % 5 50
Tubular solar collector function FT [0 ... 1] 1 0
Maximum flow rate Fx [0 … 20] l/min 0.1 6.7
Manual mode MM [0 ... 2] 1 2
Measured values
Adjustment parameter