eLine Technology ANPTZ-70-10DN - Manual (Page 40)

35
Troubleshooting
En
gl
is
h
8. TROUBLESHOOTING
There is no picture at night
• Camera is capable of seeing in extremely low light conditions (0.02
Lux), but it cannot see in total darkness. It is recommended to install
the camera where there is some ambient light (e.g. street lighting or
starlight, moonlight, etc.) or leave a light on in the area where the
camera is installed.
• Sens-Up is OFF. Go to MENU>DOME CAMERA SETUP>CAMERA
SETUP>AUTO EXPOSURE SETUP and make sure that Sens-Up is set
to AUTO. Press [Near] and adjust the Sen-Up Limit to provide the best
night time picture for your installation.
No image at startup or camera image is unclear
• Check to ensure your camera is properly connected (see “Connecting
the Camera” on page 2) and the power adapter is plugged in.
• Connect the power adapter to a different outlet.
• Make sure that the power adapter you are using meets the camera’s
power requirements (850mA / 7.2W / 12V DC).
• Extension cable run may be too long. Voltage may drop over distance
and affect image quality.
• Dome cover is dirty. Clean the dome cover with a soft, slightly damp
cloth. Do not use anything other than water to clean the dome cover,
as chemicals such as acetone can permanently damage the plastic.
eLineTechnology.com