Acer 220 Series - Manual (Page 56)

3 Troubleshooting my computer 48
connectors and there is only one PS/2 port on the computer.
To connect two PS/2-type devices to the computer, you need to use an
optional PS/2 Y-bridge connector.
The printer does not work.
Check the following:
• Make sure that the printer is connected to a power outlet and that
it is turned on.
• Depending on your connection (USB or parallel), make sure that
the printer cable is connected securely to the appropriate port on
your computer and the corresponding port on the printer.
• During POST, press F2 to access the BIOS Utility and verify that the
parallel port is enabled if you use a parallel printer.
I want to set up my location to use the internal modem.
To properly use your communications software, you need to set up
your location:
1 Click on Start, Control Panel.
2 Double-click on Phone and Modem Options.
3 Click on the Dialing Rules tab and begin setting up your location.
Refer to Windows Help and Support.
220.book Page 48 Tuesday, October 23, 2001 10:54 AM