EXP Computer PD-630 - Manual (Page 14)

5. Double click at the device you choose and select the “Resource” at the
pop-up windows, uncheck the “use automatic settings”
6. You can change the I/Os or IRQs by clicking at them
7. Make sure the “Conflicting device list” shows “No conflicts”.
8. Click “OK” when finishing, system may ask you to reboot the computer
to enable the new settings
Remove or re-install the driver
If you want to remove, re-install or upgrade the driver you have installed,
you need to remove the old driver first which can be done by highlighting the
EXP device driver under “Device Manager”, then click at “Remove” button.
DOS/Windows3.X
After rebooting your computer, the following messages will be displayed on
your screen, which are generated by EXPCDI.EXE, NTLPD.SYS and
MSCDEX.EXE.
Configure card to:
I/O Port:170-177, 376-377
IRQ Number: 15
Device Name: MSCD001
EXP portable PD/CD-ROM card is present in socket 1
PD/CD-ROM (PD) Device Driver [Version 1.00]
PD is allocated 1 device(s) as D:
.
.
.
C:\DOS\MSCDEX.EXE /D:MSCD001 /M:4
MSCDEX Version 2.25
Copyright © Microsoft Corp. 1986-1991.
Drive E: = Driver MSCD001 unit 0
If any error occurs or the PD TRAVELER does not work, you should reboot
your computer again. When the system displays 'Starting MS-DOS...', press
the F8 key to make the system executes the CONFIG.SYS and
AUTOEXEC.BAT step by step, so that you can consistently press the ‘Y’ key
to see each command's message. You can always run the INSTALL.EXE to
change the I/O port and IRQ setting.
Error messages generated by EXPCDI.EXE:
v v
Error: PCMCIA card is not present!
If the above message appears, it means EXPCDI.EXE can't find any
PCMCIA card in your PCMCIA slots. Make sure the card is inserted firmly.
v v Error: Illegal I/O port!
The above message means invalid I/O ports in the EXPCDI.EXE line of
CONFIG.SYS has been selected. The legal I/O port numbers are: 1, 2, and
3.
v v Error: There is no available 4K memory for mapping!
The above message means EXPCDI can't find available 4K memory
between C000:0 to EFFF:0. This error can be corrected by changing the
EMM386 line of CONFIG.SYS to exclude at least 4K memory for mapping.
For example,
DEVICE=C:\DOS\EMM386.EXE ... X=D000-D3FF
v v
Error: The INTEL 82365SL PCMCIA controller is not
detected in your system. You should contact your
dealer to get PCMCIA support software.
The above message means the PCMCIA controller for your system is not
INTEL 82365SL compatible. In this case, you should install PCMCIA support
software which should be supplied by the notebook manufacturer.
v v
CD-ROM Drive is not found!
The above message means EXPCDI.EXE can't find the PD TRAVELER
drive. Please make sure the CD-ROM drive is properly connected to the