AEG D2160-1 - Manual (Page 25)

CLEANING INSIDE THE OVENS
The vitreous enamel coating in the ovens can be
cleaned using normal oven cleaners or aerosol
oven cleaners with care. Ensure that the
manufacturers instructions are followed and that all
parts are well rinsed afterwards.
CLEANING THE DOOR GLASS
The main oven and second oven inner door glass
panels are removable for cleaning.
TO REMOVE THE INNER GLASS
1. Fully open the oven door.
2. Firmly grasp the rear edge of the inner glass
panel with both hands.
3. Push the glass panel towards you until it clears
the hinge location points at the rear.
4. With one hand, carefully lift the glass panel to
disengage it from the location points under the
handle. (With your other hand, hold the
outer door to ensure it does not spring
shut on removing the inner panel).
5. Close the oven door.
TO CLEAN THE INNER GLASS DOOR
PANELS
Clean the inner door glass panels using a soft cloth
and hot water to which a little washing up liquid has
been added. If the inner panel is heavily soiled,
Hob Brite may be used. Do not use abrasive
cleaning materials on the door glass. Ensure that
all parts are well rinsed and thoroughly dried before
attempting to replace the glass.
Hinge location
point
Hinge
location point
25
To prevent damaging or weakening the
door glass panels avoid the use of the
following:
l l Household detergents and bleaches
l l Impregnated pads unsuitable for
non-stick saucepans
l l Brillo/Ajax pads or steel wool pads
l l Chemical oven pads or aerosols
l l Rust removers
l l Bath/Sink stain removers
If the door glass panel becomes
chipped or has deep scratches the
glass will be weakened and must be
replaced to prevent the possibility of
the panel shattering. Please contact
your local Service Force Centre who
will be pleased to advise further.
Under no circumstances should the
door assembly be detached from the
product for cleaning. Please refer to the
cleaning instructions.
Aerosol cleaners must not come into
contact with elements or the door seal
as this may cause damage.