Nilfisk-ALTO Centix 40 User Manual
Page 68
13
CENTIX 60
english
3.4
Installing the vacuum
unit
Tips + Tricks:
•
IMPORTANT:
The socket will subsequently be in the same location as the
installation frame. Please ensure that the frame is aligned in a perpendicular
position.
•
To prevent the tube system from being blocked by long objects:
– Use short 90º elbow (12) immediately after vacuum socket.
Connect short limb to installation frame and long limb to vacuum socket.
– If you cannot use a short 90º elbow (12), e.g. with surface installations,
avoid sucking up long objects.
•
If the tops of the screws on the rear of the installation frame interfere with flush
fitting, simply saw then off carefully and slowly with a handsaw so that the
frame does not disintegrate.
•
The side section of the installation frame (11) can also be removed at the
break-off point if it interferes because of the installation dimensions.
•
For ease of installation, grease rubber seals of socket.