Burkert Type 0641 - Manual (Page 13)

13
Installation and Commissioning
DANGER!
High voltage!
Acute risk of injury from hazardous structure-borne voltage!
Risk of damage to the device due to short circuit!
▶ Work on the electrical system may only be carried out by quali-
fied electricians.
▶ Before starting work, switch off the power supply and secure to
prevent it being switched on again!
▶ Live terminals in the terminal box can cause electric shock, short
circuit or explosion. Switch off the power supply before open-
ing the terminal box.
▶ The connecting cables to the electromagnets must be secure,
and be laid so that they are adequately protected from mechani-
cal damage.
▶ Observe the applicable accident prevention and safety regula-
tions for electrical devices!
WARNING!
Pressurised system!
Interventions in the pneumatic system represent an acute risk of
injury.
▶ Work on the pneumatic system may only be carried out by quali-
fied and instructed personnel using appropriate tools.
▶ First switch off pressure before disconnecting lines and valves.
▶ Observe the flow direction during installation!
▶ Observe the applicable accident prevention and safety regula-
tions for pneumatic systems!
7.1 Assembly
NOTES!
Installation in any position.
Preferably with solenoid system mounted at the top.
The devices are suitable for individual and block assembly..
→
Clean the pipe runs.
→
Connect a dirt-trap (strainer) upstream. Note the direction of flow!
→
Seal PTFE.
→
Screwing on the pipe run. Note the direction of flow!
→
Installation / Dismounting.
NOTES!
Always connect the earth conductor!
Note for units with connecting cable: The connecting cable and the
coil are moduled together. They must not be dismantled!
→
Make electrical connections.
7.2 Commissioning
Before commissioning, ensure that
• the device has been correctly installed,
• the connections have been correctly made,
• the device is not damaged,
• all bolts are securely tightened.
english
PTB 02 ATEX 2094 X