Burkert Type 6027 - Manual (Page 6)

20
9. MALFUNCTIONS
If malfunctions occur, check whether
→
the device has been installed according to the instruc-
tions (correct direction of installation),
→
the connection has been made properly,
→
the device is not damaged,
→
all screws have been tightened,
→
the voltage and pressure have been switched on,
→
the pipelines are clean.
If the magnet is not attracting
Possible causes:
• Short circuit or coil interrupted,
• core or core area dirty.
After occurrence of an external fire
• After an external fire, check the equipment and safety
shut-off device.
• If there is visible damage, replace safety shut-off device.
english 21
10. SPARE PARTS
CAUTION!
Risk of injury and/or damage by the use of incorrect
parts!
Incorrect accessories and unsuitable spare parts may
cause injuries and damage the device and the surrounding
area.
• Use original accessories and original spare parts from
Bürkert only.
Fittings set
Coil set
Nut Nut and coil set can
be ordered com-
pletely by quoting the
identification number
of the device (see
type label).
Fittings set on
request.
Fig. 5: Spare parts
english 21
22
11. PACKAGING, TRANSPORT,
STORAGE, DISPOSAL
NOTE!
Transport damages!
Inadequately protected equipment may be damaged
during transport.
• During transportation protect the device against wet
and dirt in shock-resistant packaging.
• Avoid exceeding or dropping below the allowable
storage temperature.
Incorrect storage may damage the device.
• Store the device in a dry and dust-free location!
• Storage temperature –30 … +80 °C.
Damage to the environment caused by device com-
ponents contaminated with media.
• Dispose of the device and packaging in an environ-
mentally friendly manner.
• Observe applicable regulations on disposal and the
environment.
• Observe national waste disposal regulations.
english
Type 6027