Actron CP9125 - Manual (Page 8)

NOTE: If diagnostic trouble codes (DTCs) are already being
displayed from a previous read operation, press and hold
READ/Scr READ/Scr READ/Scr READ/Scr READ/Scroll Do oll Do oll Do oll Do oll Down wn wn wn wn key for 3 seconds and release.
6.Observe a Moving * on Display.
NOTE: If a “No Link No Link No Link No Link No Link” message
displays, cycle ignition key to
the OFF position for 10
seconds, then back ON and repeat “Reading Diagnostic
Data.”
7. View Codes on Display
NOTE: If there are no codes present,
the tool will display “0 0 0 0 0
Codes Codes Codes Codes Codes” and proceed to
display MIL Status when
READ/Scr READ/Scr READ/Scr READ/Scr READ/Scroll Do oll Do oll Do oll Do oll Down wn wn wn wn is
pressed.
• To View Codes press and
release READ/Scr READ/Scr READ/Scr READ/Scr READ/Scroll oll oll oll oll
Do Do Do Do Down wn wn wn wn key.
• If the code is a Pending
Code a Vwill be displayed.
*
No Link
P0443
P0452 V
0 Codes
3 Codes


8