Ampro Corporation XTX 820 - Manual (Page 58)

Chapter 3 Hardware
52 Reference Manual XTX 820
Pin # Signal Description
22 I
2
DAT I
2
C Data – This data line supports the I
2
C bus which supports external slave
devices only. The interface I
2
C bus is intended for support of EEPROMs
and other simple I/O-devices. The data rate is approximate 1-10kHz.
23 SMBCLK System Management Bus Clock – This signal is used to support internal
and external SMBus devices, such as temperature and battery monitoring.
24 SMBDATA System Management Bus Data – This signal is used to support internal and
external SMBus devices, such as temperature and battery monitoring.
25 NC Not Connected (SIDE_CS3*)
26 SMBALRT* System Management Bus Alert – This signal is used by SMBus devices to
signal an event on the SM Bus.
27 NC Not Connected (SIDE_CS1*)
28 NC Not Connected (DASP_S)
29 NC Not Connected (SIDE_A2)
30 PIDE_CS3* Primary Chip Select 3 – Selects host-accessible Command Block Register.
31 NC Not Connected (SIDE_A0)
32 PIDE_CS1* Primary Chip Select 1 – Selects host-accessible Command Block Register.
33 GND2 Ground
34 GND4
Ground
35 NC Not Connected (PDIAG_S)
36 PIDE_A2 Primary Drive Address Bus 2 – Used (0 to 2) to indicate which byte in the
ATA command block or control block (register) is being accessed.
37 NC Not Connected (SIDE_A1)
38 PIDE_A0 Primary Drive Address Bus 0 – Refer to PIDE_A2, pin-36, for more
information.
39 NC Not Connected (SIDE_INTRQ)
40 PIDE_A1 Primary Drive Address Bus 1 – Refer to PIDE_A2, pin-36, for more
information.
41 BATLOW* Battery Low – This external signal to the XTX 820 indicates when the
external battery is low.
42 GPE1* General Purpose Power Management Event Input 1 – This signal may be
driven low by external circuitry to signal an external power management
event. This pin is commonly connected to the chipset’s LID# input.
43 NC Not Connected (SIDE_AK*)
44 PIDE_INTRQ Primary Drive Interrupt Request (IRQ 14)– Asserted by drive when it has
pending interrupt (PIO transfer of data to or from the drive to the host).
45 NC Not Connected (SIDE_RDY)
46 PIDE_AK* Primary DMA Channel Acknowledge – Used by the host to acknowledge
data has been accepted or data is available. Used in response to
PIDE_DMARQ asserted.
47 NC Not Connected (SIDE_IOR*)
48 PIDE_RDY Primary I/O Channel Ready – When negated extends the host transfer cycle
of any host register access when the drive is not ready to respond to a data
transfer request. High impedance if asserted.
49 VCC2 +5 volts +/-5%