Gardner Bender PVC Plugs 2 thru 6 User Manual
Page 2
WARRANTY: GB ELECTRICAL, INC. warrants its
products against defects in workmanship and
materials for 1 year from date of delivery to user.
Chain is not warranted. Warranty does not cover
ordinary wear and tear, abuse, misuse, overloading,
altered products or use of improper fluid.
WARRANTY RETURN PROCEDURE: When question
of warranty claim arises, send the unit to the nearest
GB Authorized Service Center for inspection,
transportation prepaid. Furnish evidence of purchase
date. If the claim comes under the terms of our
warranty the Authorized Service Center will REPAIR
OR REPLACE PARTS AFFECTED and return the unit
prepaid.
PARTS AND SERVICE: For quality workmanship and
genuine GB ELECTRICAL parts, select an Authorized
GB Service Center for your repair needs. Only
repairs performed by an Authorized Service Center
displaying the official GB Authorized sign are backed
with full factory warranty. Contact GB Electrical
(414) 352-4160 for the name of the nearest GB
Authorized Service Center.
REPAIR AND SERVICE INSTRUCTIONS: For repair service and parts contact your nearest GB ELECTRICAL
Service Center. The Service Center will provide complete and prompt service on all GB ELECTRICAL products.
GB Electrical, Inc.
An Applied Power Company
6101 N. Baker Road, Milwaukee, WI 53209
Phone: (414) 352-4160
FAX (414) 352-2377
RPS-0137 Rev. A
03/07
Purpose
Gardner Bender PVC plugs are intended for use with GB
thermostatically controlled PVC bender blankets,
HotBoxes
TM
or the HotTubes
TM
. One plug is placed in each
end of the conduit during heating and bending operations.
Installing the PVC plug creates an air tight chamber within
the conduit. When the conduit is heated, air trapped inside
expands and helps retain original conduit shape. The heat
retained helps eliminate premature cooling experienced
when ends are left open.
Installation
1. Place the correct size PVC plug into each end of
the conduit. The rubber seal should be flush with
the conduit.
2. Turn the wing nut clockwise to tighten the seal. Hand
tight only. Using tools to tighten the plug could result
in conduit distortion and/or damage to the plug.
3. When heating and bending operations are complete,
remove the plugs.
Size
Set
2"-2
1
⁄
2
"-3"-3
1
⁄
2
"-4"
BVS-240
4"-5"-6"
BVS-460
Size
Model Number
2 Inch
BVP-20
2
1
⁄
2
Inch
BVP-25
3 Inch
BVP-30
3
1
⁄
2
Inch
BVP-30
4 Inch
BVP-40
5 Inch
BVP-50
6 Inch
BVP-60
PVC Plug Sets
PVC Plugs