GeneralAire TERsus 2000 - Manual (Page 5)

4
cHangIng tHe uV LampS
Unplug the power cord from the GeneralAire TERSus air purification system. Unscrew the two locking knobs 1.
and remove the door. (Fig. 3)
Remove Photocatalytic module. (Fig. 4)
2.
Unplug UV lights, loosen retaining knobs, and remove UV lights. (Fig. 5, 6) 3.
Replace UV Lights, re-tension retaining knobs, and replace plug-ins. 4.
Replace Photocatalytic module and filter, secure door and re-insert power cord, check sight ports to ensure lamp 5.
illumination.
Note! Ensure filter and photocatalytic module are installed in proper air flow sequence.
fIg. 1 fIg. 2
Locking Knobs
fIg. 3 fIg. 4 fIg. 5
Unplug
UV Light
Loosen Retaining
Knobs. NOTE:
Tighten only finger
tight when installing
new lamps
reSettIng SerVIce LIgHtS
On the right side of the service panel, there are arrows pointing to two small holes marked reset. One marked filter
and one marked lamp. Using a small paper clip, bend out one leg straight and insert the end of the paper clip into
only the hole corresponding to the replaced component and push lightly until the service light returns to the green
position. The computer is now reset.
Press Here to Reset