GeneralAire GA52F32 - Manual (Page 8)

8. With an ohmmeter, check continuity between the top,
center disc contact and one of the ionizing wires. The
reading should be close to 0 ohms. If not, bend the
contact to touch the ionizing bar.
9. Replace grilles, prefilters and cells. Turn ON the Air
Cleaner.
Replacing A Tungsten Ionizing Wire
Replacement wires are cut to the correct length and
have eyelets at each end for easy replacement.
1. Turn OFF power to Air Cleaner.
2. Remove cell from Air Cleaner.
3. Remove all parts of broken wire, as well as spring and
S-hook. If necessary, cell may be used temporarily
with one wire missing until a replacement is received.
4. Using needle-nose pliers, place spring hook in the
hole of the ionizing bar near cell top.
5. Place eyelet of wire over the S-hook and place S-hook
into hole on ionizing bar on other side of cell. Keep
wire tight to ensure S-hook remains in hole.
6. Using the needle-nose pliers, grab the end of the
spring and stretch towards loop in wire. Place eyelet in
wire over spring hook and release spring. See Fig 6.
7. Install cell in Air Cleaner.
8. Return power to Air Cleaner.
9. Test cell for proper operation.
Fig. 7 — Dimensions
Ionizing Bar
Spring
Wire
Fig. 6 — Replacing An Ionizing Wire
MODEL GA52F32
HOUSE SIZE n/a
AIR FLOW up to 2000 cfm
DUCT SIZE 22 x 29.1 in
CABINET DIMENSIONS 31.4 x 24.4 x 7 inches
WEIGHT 38 lbs
POWER 120 v 60 hz
Table 2 — Specifications
8