AT&T 957 User Manual
Page 21
20
IN CASE OF DIFFICULTY
Message Waiting/New Call Light Stays On
•
Make sure you have reviewed all calls.
•
Unplug the power cord for 10 seconds, then plug it back in.
Message Waiting/NEW CALL Light Flashes
•
Make sure you have reviewed all telephone company voice mail.
•
Reset the voice mail waiting indicator. Press and release N until
the screen displays
VMW RESET, press CALL LIST
+
or CALL LIST
-
until the screen displays
OFF, then press N and wait 30 seconds
for the phone to return to standby.
Screen is Blank
•
Make sure line and power cords are correctly connected.
•
You must subscribe to service from your local phone service provider
to see call information on the screen (see “About Caller Identification”
in BEFORE YOU BEGIN).
Screen Displays
The phone has received incomplete or corrupted caller identification
information from the telephone company. The phone will display as much
information as possible.
Screen Displays
Extension Used, and None Are
Check all line cord connections.
No Caller ID Information While on a Call
•
Make sure your service provides Caller ID information while you are
on a call. This is sometimes known as “Caller ID on Call Waiting,” or
“Type II Caller ID.”
•
Make sure you have the Call Waiting feature on this phone set to
ON
(see “Feature Summary” in FEATURE SETTINGS).
•
The phone cannot display the information if another phone on the
same line is in use. Make sure all extensions are on hook.
Screen Displays Wrong Date
•
The date will be corrected with the next incoming call.
•
You can correct the date manually by following the directions on
page 9.
957_book_2ATT ill at margins 11/16/00 1:40 PM Page 20