Ultra Start MCS-100 User Manual
Page 4
MCS-100
4
Version A
SECTION 3: SYSTEM OPERATION
The MCS-100 is very sophisticated, but the operation is simple. Your two button RF transmitter is easy to use for arm,
disarm, personal protection, and programming the system for many custom functions.
3.1 Remote System Arm (On)
Press and release RF transmitter button #1.
One siren chirp sound and a light flash verify the operation.
If you hear four chirp sounds, the MCS-100 has detected a faulty sensor.
3.2 Remote System Disarm (Off)
Press and release RF transmitter button #1.
Two siren chirps and two light flashes verity this operation.
Note: If you hear three chirp sounds, the system has been triggered and the alarm was activated while you were
away from the vehicle. Please refer to following chart. This diagnostic report will turn off when ignition
switch is turned on.
Diagnostic Report
Audible - Chirp
Visual - LED
Shock Sensor
3 chirps
Double Flashes
Optional Input Trigger (Mercury Switch, Microwave & etc)
3 chirps
Rapid Flashes
3.3 Personal Protection Alarm (EMERGENCY PANIC)
Press and hold down RF transmitter button #1 for approximately three seconds.
Personal Panic alarm is activated and siren sounds and lights flash for one (1) minute.
Press and release any RF transmitter button to cancel the panic alarm.
3.4 Motorcyle Finder Mode
Press and hold down RF transmitter button #3 (#1+#2) for approximately three seconds.
Lights flash for one (1) minute.
Press and release any RF transmitter button to cancel the Motorcycle finder mode.
SECTION 4: PROGRAMMABLE FEATURES
Programming Function
Programming Method
Chirp
Light
Code Program Method 1
Power On. Within 3 seconds, press button #1 of new
transmitter. Press button #1 of 2
nd
transmitter and then
press button #1 of 3
rd
transmitter.
1
1
Code Program Method 2
(4.1)
Turn Ignition On/Off 5 times. Press button #1 of new
transmitter. Press button #1 of 2
nd
transmitter and then
press button #1 of 3
rd
transmitter.
1
1
Permanent Siren Chirp Disable
Permanent Siren Chirp Enable (4.2)
Turn Ignition on. Press button #2 for 5 seconds
None
2
1
2
One Time Soft Chirp (4.3)
Press #2 before other function buttons.
Emergency Disarm (4.4)
Turn Ignition On/Off 4 times. Alarm will disarm.
2
2
Passive Mode
Active Mode (4.5)
Turn Ignition on. Press button #3 (#3 = #1 + #2) for 5
seconds.
1
2
1
2