Hellwig Sway Bar 55903 - Manual (Page 2)

559-734-7451 800-367-5480 FAX 559-734-7460
1. If equipped, remove the factory installed anti sway bar and the mounting hardware.
2. Locate holes in K-member and install the mounting brackets as shown in photo (2). Attach the
mounting brackets with 3/8-16 X 1” bolts, washers, and locknuts.
3. Lubricate and install the D-shaped polyurethane bushings on the new sway bar in locations shown in
photo (1). Attach U-plates to bushings and mount sway bar to brackets using flanged nuts. Leave
loose at this time for adjustment later.
4. If not equipped with factory sway bar mounts, remove lower shock bolt and attach angle brackets to
lower control arm as shown in photos (4) & (5) using 7/16-20 x 2-3/4” bolt with thick washer placed
between control arm and bracket. Torque bolt to 45-50 ft-lb.
5. Position the U-plates over the D-shaped poly bushings and position the new sway bar on the frame
with the center hump facing upward as shown in PHOTO (7)
. Leave loose at this time to allow
for adjustment later. SEE PHOTOS (4 &5)
4
5
6
5903 ( R-5903 ) 04/09/2007
3
2