Hellwig Air 6290 - Manual (Page 8)

9. If vehicle has a single brake hose go to step 10. If the vehicle has two brake hoses as
shown, remove factory bracket and install brake relocation bracket using 5/16” bolt and nut to
attach brake hoses to bracket. Failure to properly install bracket will result in contact between
the brake lines and leveling valve.
6090 ( R-6090) 03/09/07
10. Recheck all fasteners for proper torque and ensure adequate clearance to all vehicle com-
ponents – exhaust, brake hoses, brake lines, shocks, differential, etc. Make sure that passenger
side panhard bolt will not contact air spring during use. A minimum of 1/2” clearance is re-
quired. If necessary, remove and re-install panhard bolt with bolt head facing air spring to
provide clearance.
Single brake hose.
Dual brake hose.
Panhard bolt
Relocation Bracket