Hellwig Sway Bar 5803 - Manual (Page 3)

4. Insert 3/8 x 2-1/4” bolts into holes in control arm and fasten assembly with washers and
locknuts as shown in photo (5).
5. Orient sway bar as shown in photo (1) and attach using the 1/2” bolts washers and lock-
nuts.
6. Tighten 3/8” bolts to 20-25 ft-lb. Tighten 1/2” bolts to 40-50 ft-lb.
7. Bounce vehicle a couple of times and check installation for clearance to fuel and brake
lines and other components. After one week of driving recheck your installation and
fastener torque. Recheck on a regular basis thereafter.
ATTENTION INSTALLER: BE SURE THAT THE CUSTOMER RECEIVES THIS INSTRUC
TION SHEET, ALL IMORTANT NOTE CARDS AND THE
WARRANTY FORM
559-734-7451 800-367-5480 FAX 559-734-7460
5
5803 ( R-5803 ) 02/15/07