Hellwig Sway Bar 55907 User Manual
Page 3
6. Assemble end links as shown in the diagram and photos (4) & (5). Tighten nut until end links bulge
slightly.
7. Center sway bar in bushings and align crossbars for best fit. When satisfied with alignment of sway
bar, tighten flange nuts to 25 ft-lb.
8. Be sure that all bolts are tightened to specifications. Re-check your installation, check for clearance
on all undercarriage components; wiring, springs, fuel and brake lines.
9. Turn wheels full lock left and then right, check for clearance on tires, wheels and steering compo-
nents, brake components and hoses. If equipped with disk brakes check clearance of calipers and
hoses to shock mounting bolt, end link bracket, and end links.
10. After one week of driving recheck your installation. Re-check on regular basis thereafter.
ATTENTION INSTALLER:
BE SURE THAT THE CUSTOMER RECEIVES THIS INSTRUCTION
SHEET, ALL IMORTANT NOTE CARDS AND THE WARRANTY
FORM
559-734-7451 800-367-5480 FAX 559-734-7460
5906 ( R-5906 )
02/12/2008