Hellwig Sway Bar 6909 User Manual
Page 4
9
10
15. Insert 7/16 X 6” bolt through driver’s side rail as shown in PHOTO 9. Insert 7/16 X 5” bolt in
same manner through passenger side rail.
Insert 2-3/4” long spacer sleeve into hole so that it is
flush with the inboard wall of subframe.
16. For severe duty it is recommended that the spacer tube be welded to the outer subframe wall. If the
spacer is to be welded, review severe service end link detail on page 4 and skip to line 19. If any
welding is to be done, the installer must ensure that all hazards (fuel, electrical, etc) are eliminated
and that fuel tanks, fuel lines, brake lines, wiring, etc. are not affected by the welding operation.
559-734-7451 800-367-5480 FAX 559-734-7460
6909 (R-6909)
04/17/07
10a
Spacer tube must be
1/32” shorter than
edge of large washer.