Hellwig Sway Bar 7717 User Manual
Page 5
12. After all adjustments have been made, tighten end link mounting bolts to 35-40 ft-lb and 9/16” ad-
justment nut on end links to 70 ft-lb.
13.
Bounce the vehicle checking for clearance on all under carriage components: fuel tank, shocks,
exhaust, differential, brake and fuel lines, etc. Test drive the vehicle and recheck all clearances
and the installation alignment. Adjust as needed. Re-check your installation after one week of
driving and periodically on a regular basis.
14.
The sway bar has three end link mounting holes. The end link MUST be mounted on the
outer hole for initial use. For a firmer setting, use the inner holes. You must use the outer
mounting hole until you are accustomed to the vehicles new handling characteristics. After
driving vehicle, a firmer setting may be selected if desired. It is recommended that the outer
hole be used for street driving.
ATTENTION INSTALLER: PLEASE MAKE SURE CUSTOMER RECEIVES THIS INSTRUCTION
SHEET,ALL IMPORTANT NOTE CARDS, WARNING CARDS
AND THE WARRANTY FORM
559-734-7451 800-367-5480 FAX 559-734-7460
7717 (R-7717)
05/26/2011