Hellwig Sway Bar 55764 - Manual (Page 3)

559-734-7451 800-367-5480 FAX 559-734-7460
9. Attach clevis to lower flange of crossmember as shown in photo (2) using the 1/2” bolt washer and
locknut. The washer is placed on the back side of the crossmember. Align clevis and torque 1/2”
bolts to 50 ft-lb.
10. Re-attach the end links to the clevis using the 7/16-20 X 2-1/4” bolts.
11. Attach end links to the outer hole of the sway bar as shown in photo (2) using 7/16-20 X 2-1/2” bolts,
locknuts and washers. Align end links for best fit as shown in photo (2).
IMPORTANT NOTE –
The end link must be attached to the outer hole prior to initial use.
12. Adjust end links for best fitment of the sway bar to the vehicle.
13. When satisfied with the fit of the sway bar, torque axle U-bolts to 35-40 ft-lb.
14. Torque end link mounting bolts to 35-40 ft-lb. Tighten jam nut on end link to lock in adjustment.
15.
Bounce the vehicle checking for clearance on all under carriage components: fuel tank, shocks,
exhaust, differential, brake and fuel lines, etc. Test drive the vehicle and recheck all clearances and
the installation alignment. Adjust as needed. Re-check your installation after one week of driving and
periodically on a regular basis.
16.
The sway bar has three end link mounting holes. The end link MUST be mounted
on the outer hole for initial use. SEE PHOTO 2. For a firmer setting, use the inner
holes. You must use the outer mounting hole as shown in photo 2 until you are ac-
customed to the vehicles new handling characteristics. After driving vehicle, a
firmer setting may be selected if desired. It is recommended that the outer hole be
used for street driving.
55809(R-55809) 8/17/2010