HOMA Collet Impeller Assembly - Manual

Publication
88FN2005
Please Contact Technical Support At 203-736-8890 With Any Additional Questions
Please Be Prepared To Provide Pump Serial Number During Call
Page
1 of 2
A
B
C.
Instructions
•
Place o-ring around outside diameter and inside
diameter of distance ring, lubricate with liquid
soap, and place in impeller. (A) DO NOT USE
GREASE TO LUBRICATE.
• Lightly tap ring in with a plastic hammer.
•
Loosen all screws in impeller locking
mechanism, and pull the opposite sides to
extend the mechanism. (B)
•
Degrease inside and outside surface of locking
mechanism, shaft, and impeller borehole. Any
residual on these surfaces may cause collet to
slip.
• Place locking mechanism into impeller borehole.
(C)
• Lubricate inner o-ring in distance ring with liquid
soap.
•
Slide impeller onto shaft until locking mechanism
reaches shoulder of the shaft.
•
Be certain that the locking mechanism stays in
the proper position while installing on shaft.
You will need:
-A torque wrench with a 40 foot pound capacity
-Allen key socket and extension
-Liquid soap to lubricate o rings
Collet Impeller
Assembly