Hudson Valley Lighting BASKING RIDGE 6113 User Manual
Page 3
INSTALLATION INSTRUCTIONS
6113
Hudson Valley Lighting, Inc.
P.O. Box 7459
106 Pierces Road
Newburgh, NY 12550
(800) 814-3993
GENERAL
1. To ensure the success of the fixture installation, the following instructions and
diagram (s) must be read and understood.
2. all electrical connections must be made in accordance with the national electrical
code and local codes and ordinances. If you are unsure of the methods of
Install electrical wiring and lighting equipment ensure the services of a qualified
licensed electrician.
3. Tools NEEDED: blade screwdriver, phillips screwdriver, pliers slip joint or small adjustable
wrench, wire cutter/stripper, electric current checker, ladder and electrical tape. Note: The
important safeguards and instructions outlined in this sheet are not intended to cover all
conditions and situations that may occur. It should be understood that the common sense,
care and care are factors that cannot be built on any product. Caution and care must be
provided by the person (s) to install, operate and maintain this instrument ofillumination.
PREPARATION FOR INSTALLATION
1. turn off the ELECTRICAL CIRCUIT for lighting
ACCESSORY IS TO BE ATTACHED. Move the appropriate circuit breaker for the outside "
position or completely remove the fuse controlling the circuit.
2. If an existing fixture is being replaced, remove it and note that the wires
in the output of the electric device was attached. NOT SEPARATE ANY OTHER
WIRES THAT CAN BE BOXED. DO NOT DAMAGE THE INSULATION OF
OLDER WIRING. Under normal circumstances the black wire is the "hot" leadership
and the white wire will be "neutral" or "common" lead. A green or BARE
Copper wire is the "ground". In older buildings is always recommended
Reconfirm the wiring polarity.
3. This fixture is designed to be mounted into a standard octagon or round box. THE
the box must be securely mounted to the building's structure.
FIXTURE INSTALLATION
1. Remove replaced accessory, tones and parts of packaging. Before discarding
packaging, packaging check to make sure that all parts are found.
2. Mount the trunk mount, and scroll to the fastening loop body.
3. accessory this accessory is convertible, chains hanging and semi-flush.
CHAIN HUNG INSTALLATION
1. attach the mounting plate to the Outbox. (The Green screw should face the
floor).
2. measure 6 "lead wires to beyond the end of the chain. Trim the excess wire.
Strip the insulation off the ends of leads expose about .5 "of wire. Twist the
wire wires together. Push the wire through the leads and Earth
screwcollar loop in the Outbox.
3. attach the bare ground wire to the green or bare copper wire in the Outbox or
to the Green screw on the lock. NEVER HOLD THE EARTH WIRE TO
THE BLACK WIRE OR "HOT"! FAILURE TO FOLLOW THIS INSTRUCTION
CAN RESULT IN SERIOUS INJURY OR DEATH!
4. hold the leadership with the Summit (s) to the white wire in the Outbox.
Tie the wires together with an approved fastener (nut). Approximately 1 "
below the fastener, tightly wrap the connection with electrical tape to tape
seals the end of fixative. Make sure that there are no exposed wire or
strands that could cause a short circuit dangerous!
5. connect the wire soft fixation for the black wire in the Outbox. Fasten the
wires joined as in step 4.
6. slide the canopy in the chain and protect the canopy with ball nuts to the ceiling.
7. Twist the center column to the nipple on the wire.
8. Open end links in the chain and attach the chain to the loop ... Close the upper link
chain. Hang the chain securing the desired height. Remove the excessive chain.
Close the bottom link in the chain.
9. install the glass and the glass ring.
SEMI-FLUSH INSTALLATION