Alamo HYDRO 15 - Manual (Page 109)

Section 6 - 5
HYDRO 15 (Service Manual) 09/06
© 2006 Alamo Industrial
Fill Hydraulic Tank
Fill Hydraulic Tank with Oil:
5. Fill Tank. Fill the Hydraulic Tank (figure 7) Fill tank
till the Oil is visable in the sight Gauge (figure 8, 9 & 11 ).
This will fill tank for the start but it will have to filled again
later.
6. Fill Suction Hose with Oil. Remove the Suction
Hose at the Tank (figure 9) and fill the hose with clean oil,
THIS IS A MUST DO . The Suction Hose must be filled
with Oil to prevent Dry strat up of Pump. Dry start up of
PUMP will damage the Pump. After filling suction Hose
reinstall it and tighten down Hose Clamp.
(figure 10)
FIGURE 10 FIGURE 9
Pressure
Gauge
Sight Gauge
FIGURE 8
FIGURE 11
Return Pressure Gauges
Sight Gauge
Return Filters
Filler Cap