Hydrotech Classic Series Stenner Basic Service Manual - Manual (Page 35)

34 Maintenance Basics – FRC
BEST PRACTICE
Factory recommended
Add grease (AquaShield ® )
to dial ring for easier
turning.
10. Place dial ring boss onto the cam’s 90° end.
11. While keeping the 90° end in the boss and the cam in the
FRC channel, in a clockwise motion, place the dial ring onto
the FRC housing and snap into place.
12. Generously grease (AquaShield ® ) bottom of FRC housing
before placing index plate inside. Grease the top of the
index plate.
13. Place the spider with index pin assembly on the index plate.
The lifter tip should be positioned in the 1/2" gap in the
FRC channel.
NOTE Additional information
Spread AquaShield ® on bottom
step of ring.