Cashco SA4 - Manual (Page 3)

IOM-CA4/SA4 3
3. Shutoff the outlet block valve.
4. Relieve the trapped upstream and down stream
pres sure and loading pres sure.
SECTION VII
Item Dynamic
No. Seal Type Part Description
13 ..................... All ..........................Piston-Guide Bearing
15 ..................... All ................................ Cage O-ring Seal
16..................... UC.................................................Shim
19 ..................... All ................................................... Cage
20 ..................... All ...........................................Valve Plug
21 ..................... All ............................................ Seat Ring
27 ..................... All ............................. Dynamic Side Seal
27.1 .............. CP............................................. Cap Seal
27.2 .............. CP..........................O-ring Energizer/Seal
27.3 .............. UC .......... U-Cup Seal w/Metal Energizer
VII. MAINTENANCE
A. General:
Figure 1: Dynamic Side Seals
6. A detailed view of the dynamic side seal parts
is shown in Figure 1; an assembled ITA in
Figure 2; and a cross-sectional drawing of
the entire regulator is shown in Figure 3.
Type UC - U-Cup
Dynamic Seal
Type CP - Cap
Dynamic Seal
27
13
13
19
19
20
20
27.3
27.1
27.2
15
15
*
*
*
*
*
*
16
16
WARNING
SYSTEM UNDER PRESSURE. Prior to per form ing
any maintenance, isolate the reg u la tor from the
sys tem and relieve all pressure. Failure to do so
could result in personal injury.
1. The regulator may be serviced without re mov-
ing the regulator from pipeline. The reg u la tor
is designed with quick-change trim to simplify
maintenance.
2. Record the nameplate information to req ui si-
tion spare parts for the regulator. The in for-
ma tion should include: Size, Product Code,
and Serial Number.
3. Refer to Section IX for recommended spare
parts. Only use original equipment parts sup-
plied by Cashco/KM for re build ing or re pair ing
regulators.
4. Owner should refer to owner's procedures for
removal, handling, cleaning and disposal of
nonreuseable parts, i.e. seals, etc.
5. The Inner Trim is re moved and replaced in the
body (23) as an assemblage of parts. The
Inner Trim Assembly, here in af ter called ITA,
consists of the fol low ing parts:
5. The regulator may now be disassembled for
inspection and pre ven ta tive main te nance while
in-line.
B. Main Regulator Disassembly:
1. Shut down system in accordance Section VI.
2. Disconnect loading pressure supply line from
loading chamber. Loosen the diaphragm
fl ange bolts (12) and nuts (11) uniformly.
Remove all bolting and nuts.
3. Place matchmarks on body (23) and loading
chamber (4) fl anges. Remove the loading
cham ber by lifting vertically. NOTE: Seal (28)
may fall out of loading chamber recess.
4. Remove diaphragm(s) (9) and examine to
de ter mine if failed. If diaphragms failed, de-
ter mine if op er at ing con di tions are ex ceed ing
designed pressure or tem per a ture limits.
5. Evenly loosen the three cage cap screws (18)