Controls panel, Configurations, Functions and controls – Audison LRX 5.600 User Manual
Page 8
8
CONTROLS PANEL
LIMIT (orange LED)
It indicates the Overload Limiter circuit is on.
Caution:
When this led is on (although sporadically), it means the applied load is a hard one. The activation
of Overload Limiter circuit (output power limiter) will anyway allow the amplifier to function
without distortions. In case Overload Limiter gets on too frequently (at every power peak), you will
need to check if there are any failures or a too hard load (that’s to say impedance is about 50%
lower than the minimum recommended one). The amplifier can go on functioning in these
conditions but power will inevitably decrease.
1
ON (green LED)
It indicates the amplifier is on.
2
1
2
3
4
5
10
9
8
6
7
11
FUNCTIONS AND CONTROLS
17
CONFIGURATIONS
FRONT/WF
REAR/TWEETER
SUB
IN-REAR
PRE-OUT
IN-SELECT
MIXED SUB*
IN-SUB
MODE
CH SELECT
PRE IN
1
1IN/SUB
F3
F1
3
*SUB
FR
MC
FR
3 CH
1IN/SUB
F1
BRIDGED
F2
BRIDGED
F2
NOT USED
2
*SUB
FR
MC
FR
2IN/SUB
F1
F2
F3
4
F3
*SUB
FR
MC
FR
5 CH
1IN/SUB
F1
F2
F4
5
*SUB
FR
MC
FR
F1
1 IN
F2
(RIGHT)
(LEFT)
BRIDGED
F2 (RIGHT) F4
F4
BRIDGED
F2 (LEFT) F4
F3
1 IN
3 CH
NOT USED
IN REAR
NOT USED
2 IN
5 CH
* MIXED SUB (F+R)/IN SUB switch can be set as follows:
- MIXED SUB (F+R): sub is driven by Front and Rear signals together
- IN SUB: sub is driven by the special input.
1IN/SUB
CONFIG.
12dB
12dB
24dB
24dB
24dB
24dB
24dB
12dB
12dB
12dB
12dB
12dB
12dB
12dB
12dB
12dB
12dB
1 IN
MC
FR
5 CH
*SUB
FR
CONFIGURATIONS TABLE
CONTROLS PANEL DIAGRAM AND CONFIGURATION SWITCHES
LRx 5.600 can be configured as follows:
Config. 1 = 5 Ch.: Front (Hi 12dB) + Rear (Hi 12dB) + Sub (Lo 24dB); IN Front (1 IN); Input Sub (IN Sub/IN Front)
Config. 2 = 5 Ch.: Front (Hi 12 dB) + Rear (Hi 12dB) + Sub (Lo 24dB); IN Front/Rear (2 IN); Input Sub (IN Sub/IN
Front + Rear)
Config. 3 = 3 Ch.: Front L + R (Hi 12dB) + Sub (Lo 24dB); IN Front (1 IN); Input Sub (IN Sub/IN Front + Rear)
Config. 4 = 5 Ch. Multichannel: Woofer (Hi/Lo 12dB) + Tweeter (Hi 12dB) + Sub (Lo 24dB); IN Front (1 IN); Pre
Out: (Hi 12dB)
Config. 5 = 3 Ch. Multichannel: Woofer L + R (Hi/Lo 12dB) + Sub (Lo 24dB); IN Front (1 IN); Pre Out: (Hi 12dB)