Dimensions installing the cleaning unit, Cleaning unit – Hach-Lange Cleaning Unit User Manual
Page 3
3
Cleaning Unit
Dimensions
Installing the cleaning unit
Refer to
Figure 4 on page 4
and the following instructions for installation.
1. Slide the O-ring (
item 6
) and the sleeve insert (
item 7
) over the sensor cable.
2. Put the O-ring over the thread of the sensor and attach the sleeve insert to the sensor.
3. Put the male fitting (
item 12
) into the sleeve insert (
item 7
). Hand-tighten to secure.
4. Put the air tubing
1
(
item 10
) into the male fitting and secure it using the cable-tie
(
item 11
).
Figure 2 Items supplied with the cleaning unit
1
1
Sleeve
7
Sleeve insert
2
Cleaning insert set (with 2 pre-assembled O-rings)
8
Male fitting (thread 1/8", for ID 6 mm tube)
3
Cleaning insert
9
Cable tie
4
O-ring
10 Adapter, 1.5 inch NPT external thread
5
Sleeve insert set (with 2 pre-assembled O-rings)
11 Union nut
6
O-ring
1
Items supplied are subject to change without notice
Figure 3 Dimensions
1
Use pressure and UV resistant tube with an inner diameter of 6 mm.