Placing the probe in the service position – Hach-Lange LZX414.00.60000 User Manual
Page 14
Advertising
12
Rail mounting hardware
Placing the probe in the service position
1. Remove the spring locking pin from the fastening lug and pull the brackets with the
mounting pipe from the fastening lug.
2. Slide the mounting pipe onto the fastening lug using the bottom bracket
(
Figure 15 on page 13
).
3. Pull the spring locking pin out of the angle and pull the supporting pipe back to the
base until the clamp is in contact with the base.
Figure 14 Installed rail mounting
Advertising