INTELLINET NETWORK NSC11-WN Quick Install Guide - Manual (Page 3)

- 3 -
ENGLISH
Connecting to the Camera
Connect the RJ45 network cable from the camera’s LAN port to your
network; e.g., the router or a LAN switch, then power on the camera. The
boot sequence will take about one minute.
By default, the network camera searches for a DHCP server on the network
and obtains an IP address automatically. A very common DHCP server is a
router, a device that is found on most networks. The presence of a DHCP
server on your network simplifies the installation and users with limited
knowledge of TCP/IP networks can install the network camera in minutes. If
no DHCP server is found, the network camera will revert to its default IP
address: 192.168.1.221.
On Windows systems, you want to use the IPCam Admin Utility that finds the
camera on the network and lets you make changes to the configuration.
Once the camera is set up properly, it can be accessed with the computer’s
Web browser.
Windows XP, Vista and Windows 7
Insert the Installation CD into the CD or
DVD drive. After a few moments, the
CD will automatically start and display
the screen to the right. If that does not
happen, you need to browse the CD
with Windows Explorer and double-click
the autorun.exe file.
1. User Manuals
The user manual for the INTELLINET Network Camera is available in
electronic form on the installation CD. If you encounter differences
between the screen shots shown in the user manual and the actual screen
contents, it is recommended that you open the manual from the CD, as it
may be a newer edition than the printed version.