INTELLINET NETWORK NSC11-WN User Manual User Manual
Page 14
14
1.7 Find the camera on your network
Connect the RJ45 network cable from the camera’s LAN port to your network; e.g.,
the router or a LAN switch, then power on the camera. The boot sequence will
take about one minute. By default, the network camera searches for a DHCP
server on the network and obtains an IP address automatically. A very common
DHCP server is a router, a device that is found on most networks. The presence
of a DHCP server on your network simplifies the installation and users with limited
knowledge of TCP/IP networks can install the network camera in minutes. If no
DHCP server is found, the network camera will revert to its default IP address:
192.168.1.221.
On Windows systems, you want to use the IPCam Admin
Utility that finds the camera on the network and lets you
make changes to the configuration.