INTELLINET NETWORK 560665 8-Port High-Power PoE Web-Smart Switch - Manual (Page 2)

2
ENGLISH
PoE+ Web-Smart Switch English
For specifications and detailed instructions, refer to the user manual on the
enclosed CD or at intellinet-network.com.
CONNECTIONS & INDICATORS
Ports
Each of the eight ports
can be used to deliver
both power (up to
30 watts per port)
and data to remote
devices. All ports on the switch support Auto-MDI/MDI-X functionality, so
crossover cables and uplink ports are not needed for connections to PCs,
routers, hubs, other switches, etc. If an LED doesn’t indicate a link or activity,
check the corresponding device for proper setup and operation.
LEDs
The Power, PoE and Link/
Act LEDs make it easier to
monitor connections.
NOTE: Powered devices
should also comply with
IEEE 802.3af.
Power
On the rear panel, plug in the included power
cord and connect the switch to an AC outlet.
Toggle the Power switch to On and confirm that
the Power LED is lit.
INSTALLATION
Prior to use, position the switch:
• on a level surface with 25+ mm (approx. 1”) of clearance for ventilation;
• away from sources of electrical noise: radios, transmitters, amplifiers, etc.;
• within 100 m (approx. 328’) of connected network devices.
For rack mounting, align the two brackets with the holes on each side panel
and screw in place.
LED Status Operation
POWER
On Power on
Off Check the AC connection; power on
PoE On Port is linked to a PoE device
Off No PoE device is linked
LINK/ACT On Valid port connection
Blinking Valid connection; data transmitted/received
Off No link established
8 RJ45 10/100M ports
OFF
ON
2 4 6 8
POWER
LINK /ACT
PoE
PoE
LINK /ACT
1 3 5 7
2 4 6 8
1 3 5 7
Reset