IQinVision Alliance-mx - Manual (Page 10)

10
1. Insert the IQtools CD into the CD drive of the PC. Once the CD starts, run
IQfinder either from the CD by clicking “Scan for IQeye cameras on my
network” or by installing IQfinder on the local machine by selecting “Install
IQfinder”.
2. Click “Scan for IQeye cameras on my network” to find IQeye cameras (Figure
13.1). The detected cameras will be displayed in
the IQfinder window. Select a camera from the list
and click “Assign IP” to edit the selected camera’s
network settings.
3. The “Assign IP” window allows the IP address,
Subnet, and Gateway of the camera to be changed
and alternatively the camera to be configured for
DHCP operation. Click the ”Apply” button after
making the desired changes (Figure 13.2).
NOTE: Changing between a static IP address and DHCP will cause the
camera to reboot.
4. To view a camera, double click a camera entry or
highlight a camera in the list and click the “Web Page”
button (Figure 13.3). The “Live” page will be displayed
through the default browser (IE recommended). It is
also possible to open Internet Explorer and enter the IP
address of the IQeye camera
in the address field of the browser. If prompted, install
the Active X control (Figure 13.4).
5. To perform further configuration of the camera
click on the “Setup” tab.
NOTE: The default username is “root” and the default password is
“system”.
6. To prepare the camera to serve the H.264 stream
(Alliance-mx), select H.264 from the video format
drop-down (Figure 13.5). To view the H.264 stream full
screen (without “Live” page controls), double
click on the video area. Double click on the video
image again to return back to the “Live” page.
7. For additional information and technical
documents, please visit www.IQeye.com.
Figure 13.1
Figure 13.2
Figure 13.3
Figure 13.4
Figure 13.4