IQinVision Alliance-mini Series IQD5x - Manual (Page 6)

3. Remove the camera shroud by placing your
palm over the top of the shroud, then gently
squeeze the two tabs toward the front of the
shroud toward the center of the camera.
Pivot these tabs away from the camera, then
pull the shroud off the camera as shown in
Image 6.3.
4. Set the field-of-view using the camera’s
3-axis gimbal.
5. Focus the camera.
Varifocal Lens: Adjust the field-of-view
and focus rings to focus the lens. Be sure
to lock the lens ring thumbscrews when
desired focus is achieved as shown in
Image 6.4.
Fixed Focal Lens: Focus the lens by
twisting the lens clockwise or counter
clockwise to achieve the desired focus.
Then lock the lens in place by tightening the
locking ring as shown in Image 6.5.
6. Replace the camera shroud by first
positioning the shroud against the rear
shroud tab, then pivoting the shroud
down toward the front two mounting
tabs. Squeeze the shroud gently and
push it down to engage the front two
mounting tabs.
7. Replace the trim cover.
Position the dome cover so the dome
cover screws line up with the matching
receiving holes on the mounting plate
(Image 6.6). Tighten the dome cover to
the mounting plate using the supplied
Torx T-10 security wrench.
Note: The cover fits in only one orientation. Do not apply
excessive force, or damage to the trim cover may occur. If it
does not push down easily on to the camera, the cover may
be flipped 180° from the correct orientation. Remove the
cover, flip it 180° and try again. An easy way to identify the
correct orientation is to look for the “Activity LED” hole in
the trim ring and align that on the same side of the camera
as the Activity LED.
Image 6.3
Image 6.5
Image 6.6
6
Image 6.4